Ricoh B051 Service Manual page 1198

Firmware History for B051/B052
SERVICE PROGRAMS (New Defaults → Old Defaults):
105* Fusing Temperature
1 Heating: Idling
2 Heating: Ready
3 Heating: Standby
4 Heating: Plain/1 Color
5 Heating: Plain/Full
Color
6 Heating: Middle
Thick/1 Color
7 Heating: Middle
Thick/Full Color
8 Heating: Thick/1 Color
Heating: Thick/Full
9
Color
10 Heating: OHP/1 Color
11 Heating: OHP/Full
Color
12 Heating: Duplex/1
Color
13 Heating: Duplex/Full
Color
14 Pressure: Idling
CÓPIA NÃO CONTROLADA
Sets the temperature at which the heating roller starts idling.
[100 ~ 180 / 145 / 1°C/step]
Sets the temperature at which the heating roller enters the print
ready condition.
[100 ~ 180 / 155 (165) / 1°C/step]
Sets the heating roller temperature for the ready (standby)
condition. After the main switch has been turned on, the
machine enters this condition when the heating roller
temperature reaches the temperature specified in this SP mode.
When the machine is recovering from energy saver or auto off
mode, the machine becomes ready when both heat and
pressure roller temperatures reach the specified temperature.
Pressure roller: SP1-105-16
[100 ~ 180 / 160 (175) / 1°C/step ]
Sets the heating roller temperature for thin paper in single-color
mode.
[120 ~ 190 / 155 (160 )/ 1°C/step]
Sets the heating roller temperature for thin paper in full-color
mode.
[120 ~ 190 / 160 (170) / 1°C/step]
Sets the heating roller temperature for normal plain paper in
single-color mode.
[120 ~ 190 / 165 (170) / 1°C/step]
Sets the heating roller temperature for normal plain paper in full-
color mode.
[120 ~ 190 / 170 (180) / 1°C/step]
Sets the heating roller temperature for thick paper in single-color
mode.
[120 ~ 190 / 165 (170) / 1°C/step]
Sets the heating roller temperature for thick paper in full-color
mode.
[120 ~ 190 / 170 (175) / 1°C/step]
Sets the heating roller temperature for OHP sheets in single-
color mode.
[120 ~ 190 / 165 (170) / 1°C/step]
Sets the heating roller temperature for the OHP sheets in full-
color mode.
[120 ~ 190 / 175 (180) / 1°C/step]
Sets the heating roller temperature for duplex printing (both
sides) in single-color mode.
[120 ~ 190 / 150 (155) / 1°C/step]
Sets the heating roller temperature for duplex printing (both
sides) in full-color mode.
[120 ~ 190 / 155 (165) / 1°C/step]
Sets the temperature at which the pressure roller starts idling.
[30 ~ 100 / 10 / 1°C/step]
CÓPIA NÃO CONTROLADA
Page 24 of 37