Ricoh B051 Service Manual page 1171

BULLETIN NUMBER:
APPLICABLE MODEL:
GESTETNER – DSC224/DSC232
LANIER – LD024C/LD032C
RICOH – AFICIO 1224C/1232C
SAVIN – C2408/C3210
SUBJECT: DEVELOPMENT ROLLER HANDLE
GENERAL:
Important notes regarding the development roller handle
The development roller handle shown below has been included inside the mainframes and development
units spare part from the beginning of mass production, and is also registered with service parts as P/N
G0703499 for use with KCMY development units. This handle is used to perform manual rotation of the
development roller at unit installation (see Service Manual excerpt below).
Please be sure to keep this handle together with all other maintenance tools (do not dispose of the
handle), as this part will be removed from mainframes and development unit accessories beginning at
some point in the near future (TBA). This handle is being removed from machines/accessories since
only one is needed per field technician.
The handle will however remain an active service part under its existing P/N shown above.
[C]
[B]
Service Manual excerpt:
8. Keep the development unit level and shake the development unit about 10 times from side to side.
NOTE 1: Do not touch the development roller or the development roller gear.
NOTE 2: Use caution not to drop the cartridge or to damage it.
NOTE 3: If the cartridge has not been shaken well, the machine takes a longer time to
initialize the development unit, or an error message or SC350 is displayed.
When either of them is displayed, turn the main switch off and on.
9. Engage the special tool [A] (distributed with the machine) with the development roller gear at the
rear [B].
Copyright  2004 RICOH Corporation. All rights reserved.
CÓPIA NÃO CONTROLADA
TECHNICAL SERVICE BULLETIN
B051/B052 – 044 REISSUE
CÓPIA NÃO CONTROLADA
09/03/2004
[A]
Development
roller handle
Page 1 of 3