Ricoh B051 Service Manual page 1083

Rev. 04/2004
Mode No.
2
(Class 1, 2, and 3)
942 OPC Lubricant Interval
1 OPC Lubricant Interval
944 OPC Lubrication: High Coverage
1 Setting
2 Image Coverage–1
3 Image Coverage–2
4 Sheets–1
5 Sheets–2
SM
CÓPIA NÃO CONTROLADA
The machine lubricates the OPC belt and image transfer
belt at the interval (number of prints) set with this SP.
Incoming print jobs do not interrupt the lubrication.
[10 ~ 65535 / 50 / 10/step] DFU
Set SP2-939-1 to 1 to execute the forced OPC
lubrication.
Enables/disables OPC lubrication after a certain amount
of images are printed. The lubrication timing depends on
SP2-944-2 to -5.
0: Disables 1: Enables
When high coverage images are continuously printed,
cleaning of the OPC may not be enough. To correct this,
OPC lubrication is carried out during printing (lubrication
time: around 34 seconds).
Specifies standard average coverage condition 1.
[50 ~ 800 / 300 / 10 units/step]
OPC lubrication is executed under the following
conditions.
After the previous OPC lubrication, the number of output
pages reaches the value specified with SP2-944-4.
The average coverage of the outputs after the previous
OPC lubrication exceeds standard average coverage
condition 1.
Specifies standard average coverage condition 2.
[50 ~ 800 / 200 / 10 units/step]
OPC lubrication is executed under the following
conditions.
After the previous OPC lubrication, the number of output
pages reaches the value specified with SP2-944-5.
The average coverage of the outputs after the previous
OPC lubrication exceeds standard average coverage
condition 2.
[10 ~ 80 / 20 / 1 sheet/step]
[10 ~ 80 / 40 / 1 sheet/step]
5-19
CÓPIA NÃO CONTROLADA
SERVICE PROGRAM MODE
Function / [ Setting ]
[0 ~ 1 / 1 / 1 /step]
B051/B052