Ricoh B051 Service Manual page 1091

Rev. 04/2004
Mode No.
3
(Class 1, 2, and 3)
940 Job End Interruption
1 Job End Interruption
970 Image Area Rate
1 M
2 C
3 Y
4 Bk
971 Toner Revitalization
1 Toner Revitalization
980 1C Idling
1 1C Idling
SM
CÓPIA NÃO CONTROLADA
The OPC belt is lubricated after the end of every job
(SP2–941–1). This SP determines whether the
lubrication is interrupted when a job arrives at the printer.
[0 ∼ 1 / 0 / 1 /step]
0: Interrupted
1: Not interrupted
Specifies the minimum image area (expressed as a
percentage of an A4 page) required to maintain optimum
development unit condition (
SP3–971).
[0 ~ 10.0 / 2.0 / 0.1 %/step]
After 20 sheets over a number of small jobs (or after 50 sheets
in one job), if the developed area is less than the value of this
SP mode, toner is transferred to the image transfer belt and
cleaned off. This is performed during the doctor roller reverse
rotation.
[0 ~ 10.0 / 2.0 / 0.1 %/step]
[0 ~ 10.0 / 2.0 / 0.1 %/step]
[0 ~ 10.0 / 3.0 / 0.1 %/step]
Enables/disables the toner revitalization.
[0 ~ 1 / 0/ 1 /step]
0: Disables
1: Enables
Continuous printing with a relatively low coverage ratio (CMYK
less than 5% each) tends to reduce the charge potential of the
toner, because the toner remains in the hopper for a long time.
This can lead to spots on the copy. Toner revitalization
removes this defective toner periodically.
Enables/disables 1-color idling after paper transfer.
[0 ~ 1 / 0 / 1 /step]
0: Disables
1: Enables
Set this to 1 if the user complains about diagonal lines in solid
areas of prints that only use one toner color (M, C, or Y).
5-27
CÓPIA NÃO CONTROLADA
SERVICE PROGRAM MODE
Function / [ Setting ]
Toner Revitalization:
B051/B052