Table of Contents
Advertisement
Important • While the machine is processing a job, do not pull out the tray.
2
Remove any paper loaded in the tray.
3
With the side to be copied or printed on
facing up, load approximately 50 to 100
sheets of paper in the tray and align the
edges of the paper in the arrow direction (1).
Hold the long-side paper guide and slide it to
the desired paper size (2).
Important • Do not load paper exceeding the
4
With the side to be copied or printed on
facing up, load the remaining paper and
align the edges of the paper in the arrow
direction (1). Hold the short-side paper guide
on the left side and slide it to the desired
paper size (2).
Important • If the number of sheets is 100 or less, the
5
Push the tray in gently until it comes to a stop.
Loading Tab Paper in the Tray 6 (HCF (A3 1 Tray))
Following describes the procedure for loading tab paper in the Tray 6 (HCF (A3 1 Tray))
(optional).
Important • Tab paper cannot be loaded on the Trays 1, 2, 6 (HDF (A4 2 tray)), and 7 (HDF (A4 2 tray)).
Note
For information about changing the paper size and orientation, refer to "Changing the Paper Size for the
Tray 6 (HCF (A3 1 Tray))" (P.63).
1
Pull out the Tray 6 towards you until it stops.
CAUTION
When pulling out the paper tray,
do it slowly. If pulled out with too
much force, the tray can hit and
injure your knees.
Important • While the machine is processing a job, do
• Do not add a new stack of paper on top of the remaining paper in the tray, in order to prevent
paper jams or any other troubles. First, remove the remaining paper in the tray, then load the
new stack of paper.
maximum fill line. It might cause paper
jams or machine malfunctions.
paper guides touch too tightly against the
paper, causing the paper to deform and
resulting in paper jams.
• Position the guides correctly to match the paper size. If the position of the guide is not
correct, the paper may not be fed properly and cause paper jams.
• Tab paper can be used only for [Tab Margined Shift], Covers, and Separators.
• Before loading paper in a tray, fan the paper well. It prevents paper from sticking to each
other and reduces paper jams.
not pull out the tray.
• Do not add a new stack of paper on top of the remaining paper in the tray, in order to prevent
paper jams or any other troubles. First, remove the remaining paper in the tray, then load the
new stack of paper.
Loading Paper
4
57
Advertisement
Table of Contents
