Table of Contents
Advertisement
5
Move the two paper guide levers while
holding their grips so that they lightly contact
the edges of the paper.
6
Push the tray in gently until it comes to a
stop.
Loading Paper in the Tray 5 (Bypass)
When printing or copying with paper sizes or types that cannot be set in the Trays 1 to
4, 6, and 7, use the Tray 5 (Bypass).
The following describes how to load paper into the Tray 5 (Bypass).
To make detailed instructions for printings, specify the instructions using the [Tray/
Output] tab in the print driver. When doing this, also specify the type of paper to load.
Note
1
Open the Tray 5 (bypass) as necessary.
Note
2
Hold the center of the paper guides and slide
them to the desired paper size.
3
Load paper with the side to be copied or
printed on facing up, and insert the paper
lightly along the paper guide until it comes to
a stop.
Important • Do not load mixed paper types into the
4
When loading a non-standard paper size on
the Tray 5 (bypass), move the paper guides to accommodate the paper.
• When adding paper to tray 5 (bypass), remove any paper remaining in the tray, add it to the
bunch of papers to be added, then load all of the paper into the tray at once.
• Before loading paper in a tray, fan the paper well. It prevents paper from sticking to each
other and reduces paper jams.
• If necessary, extend the extension flap.
The extension flap can be extended in
two stages. When pulling out the
extension flap, do it gently.
tray.
• Do not load paper exceeding the
maximum fill line. It might cause paper
jams or machine malfunctions.
Loading Paper
4
55
Advertisement
Table of Contents
