Table of Contents
Advertisement
6
Turn the knob 2f as necessary, and then
remove the jammed paper.
7
Shift the lever 3b on the right of the fuser unit
as necessary and then remove the jammed
paper.
Important • If the jammed paper remains inside and it
8
Insert the transfer module completely and
turn the green lever 2 to the left.
Note
9
Close the front cover.
Note
Paper jams Inside the Finisher Left Cover
This section describes how to clear paper jams at the following locations.
Paper Jams at the Lever 1a and the Knob 1c.............................................................................. 97
Paper Jams at the Lever 1d......................................................................................................... 98
Paper Jams at the Lever 1b......................................................................................................... 99
Note
Paper Jams at the Lever 1a and the Knob 1c
1
Make sure that the machine has stopped
before opening the left cover of the finisher.
is difficult to remove, pull out the duplex
module after returning the transfer
module to the original position.
• If you cannot turn the lever, pull out the
transfer module halfway and insert it
again.
• If the front cover is not completely closed, a message will appear and the machine will not
operate.
• The jam clearance procedure differs for each jam location. Follow the instructions control
panel and remove the jammed paper.
Paper Jams
6
97
Advertisement
Table of Contents
