Correcting The Curl Of Outputs (When Only A Finisher Is Installed) - Fuji Xerox 4127 Quick Reference Manual

6 Problem Solving

Correcting the Curl of Outputs (when Only a Finisher is Installed)

You can correct the curling of the output by pressing the De-curl button.
The De-curl button functions when the machine is in operation or idle as long as its
power is on.
Note
1
Check the direction of the curl of the output
copy.
2
Check that De-curl button is lit.
Note
6
3
Press the De-curl button.
Note
For more information, refer to "Mode and function of <De-curl> button" (P.125).
124
• To change the curling correction mode while the machine is in operation, press the De-curl
button and then the change will be applied immediately.
• Pressing the <Clear All> button on the control panel cannot change the curling correction
mode.
• When the machine is switched on, the the
curl correction mode is set to Auto.
• When the power saver mode is canceled,
the curl correction mode is set to Auto.
• Pressing the De-curl button switches between the Auto, ON, and OFF modes.