Punch Option Setting - Konica Minolta bizhub C353 Service Manual

5. Finisher
10. Adjust with the [+]/[-] Keys.
When the stapling position is shifted to the direction A: Adjust the value to the +
side.When the stapling position is shifted to the direction B: Adjust the value to the -
side.
11. Touch [END].
12. Turn OFF the main power switch, then wait for 10 sec. or more and turn ON the main
power switch.
13. Make the copy and check again.
5.2

Punch option setting

• To set installation and model of the punch kit.
Functions
• To set the number of holes to be made by the punch kit installed.
Use • Use when the punch kit is installed.
• The default setting is Non-installat.
1. Touch [PK-501].
Setting/
2. Select the number of punch holes to be made corresponding to the model and destina-
Procedure
tion.
3. Touch [decision].
4. Turn off the main power switch and turn it on again more than 10 seconds after.
40
Field Service Ver. 2.0 Jan. 2008