Replacing The Feed Roller - Konica Minolta Magicolor 8650 Service Manual

Field Service Ver. 1.0 Oct. 2007
2.1.2

Replacing the feed roller

A. Periodically replaced parts/cycle
• Feed roller: Every 300,000 prints
NOTE
• Replace the separation roller assy, feed roller and pick-up roller at the same time.
B. Replacing procedure
1. Remove the rear right cover. (Remove the right lower cover for 4th row.)
See P.13
2. Remove the paper feed tray 4. (Remove the paper feed tray 5 from 4th row.)
3. Remove the paper separation roller mounting bracket assy.
See the procedures 1 to 3 in P.3 "Replacing the separation roller assy."
[1]
Confidential – for internal use only, do not distribute
4. Disconnect the connector [1] and
[2]
[1]
A093F2C018DA
5. Remove four screws [1] and remove
[2]
A093F2C019DA
2. Periodical check
remove the harness from two wire
saddles [2].
the feed unit [2].
5