Change Warmup Time; Status Led Setting - Konica Minolta Magicolor 8650 Service Manual

Field Service Ver. 2.0 Nov. 2007
10.3.16

Change Warmup Time

Functions • To change the warm up time.
Use • With the warm-up time set to mode 1, if monochrome printing is made immediately
after a warm-up cycle and a paper curl problem occurs, change the setting to mode2.
• With the use of recycled or low quality paper, if a paper curl problem or other paper
curl related failures occur immediately after a normal warm-up cycle, set the setting
to mode 3 or mode 4. Other paper curl related failures include jam, paper ejection
failure, and punch/staple/fold position failure.
The following table shows the warm-up time (normal warm-up) in each mode.
Mode 1
Mode 2
Mode 3
Mode 4 Monochrome: 130 sec./Color: 130 sec.
Setting/ • The default setting is Mode 1.
Procedure
10.3.17

Status LED Setting

A. Paper Remaining
Functions • To set how to display main body statuses on the machine state LED (state display
lamp, paper empty lamp).
Use
• Each of Type1 and Type2 has the following LED display forms.
Amount of paper
remaining
(Tray 2 and 3)
Amount of paper
remaining
(Tray 4 and 5, LCT)
Setting/ • Each default setting is Type 1.
Procedure
NOTE
1
• [Type 2] is the default setting, if the firmware of function enhanced version 1 or
later is mounted.
Confidential – for internal use only, do not distribute
Monochrome: 75 sec./Color: 75 sec.
"Mode 1" Mode 2
Machine State LED Setting
100 % to 66 % of paper remaining
Near empty
Empty
Being lifted up
Door opened or closed
100 % to 33 % paper remaining
33 % to near empty
Near empty
Empty
Being lifted up
Door opened or closed
"Type 1"
10. Service Mode
Mode 3 Mode 4
Type1
Unlit
Blinking
Lit
Unlit
Unlit
Blinking
Blinking
Lit
Unlit
Type 2
Type2
Unlit
Unlit
Lit
Unlit
Unlit
Unlit
Unlit
Lit
Unlit
217