Adjustment Of The Folding Position - Konica Minolta Magicolor 8650 Service Manual

Field Service Ver. 1.0 Nov. 2007
5.2

Adjustment of the folding position

• Folding position is adjusted by adjusting the tray section and the saddle section.
• Adjust the folding position by aligning the tray section. Adjust the position of the saddle
section if the position is still not proper.
<Deviation amount which will be adjusted>
Amount of deviation which will
Paper Size be adjusted by aligning the Tray
A3
A4
B4
Ledger
Letter
5.2.1 Adjustment procedure
A. Checking the deviation amount
Deviated downward
Exit
direction
B. Adjusting the folding deviation
1. Turn power switch OFF, and remove the finisher from the machine.
Confidential – for internal use only, do not distribute
Amount of deviation which will
be adjusted by aligning the
Section Saddle Section position
0.55 mm
0.4 mm
0.5 mm
0.55 mm
0.35 mm
Deviated upward
Exit
direction
4583F3E525DA
[3]
[1]
[4]
[2]
A0D6F2C511DA
5. Mechanical adjustment
Total amount which
0.55 mm
0.4 mm
0.5 mm
0.55 mm
0.35 mm
1. Load the paper take-up tray with A3
or 11 x 17 paper.
2. Run a test print cycle in the center
staple mode.
3. Check the test print for folding devia-
tion.
2. Raise the horizontal transport unit [1]
straight upward and, keeping that
condition, disengage the lock lever
[2] and remove the horizontal trans-
port unit [1].
NOTE
• At reinstallation, be sure to engage
the lock lever [2] in position.
• At reinstallation, make sure that the
gear [3] of the finisher is in positive
mesh with the gear [4] of the hori-
zontal transport unit.
will be adjusted
1.1 mm
0.8 mm
1.0 mm
1.1 mm
0.7 mm
39