Punch Reg. Loop (Pk-515); Punch Option; Punch Kit Type; Of Punch-Holes - Konica Minolta Magicolor 8650 Service Manual

Konica minolta magicolor 8650 laser printer service manual

Hide thumbs Also See for Magicolor 8650:

Table of Contents

Field Service Ver. 1.0 Oct. 2007

Punch Reg. Loop (PK-515)

This adjustment must be made in any of the following cases:

• When a slant occurs in the punch hole position.

• When misfeed frequently occurs in punch hole mode.

1. Call the Service Mode to the screen.

See P.202 of the main body service manual.

2. Select [Finisher Adjust] → [CB-FN Adjust] → [Punch Reg. Loop].

3. Press the Menu/Select key.

4. Set the correction value using the

• Adjustment range: +4 max. and -4 min. (1 increment: 1 mm)

• To make loop length larger, enter a positive value.

• To make loop length smaller, enter a positive value.

5. Press the Menu/Select key.

6. Turn OFF the power switch, wait for 10 sec., then turn the switch ON.

7. Make a print again and check the deviance of punch hole position.

• To set installation and model of the punch kit.

• Use when the punch kit is installed.

• The default setting is Not Installed.

• Select the model of the punch kit currently installed.

• To set the number of holes to be made by the punch kit installed.

• Use when the punch kit is installed.

• The default setting is 2-Hole.

• Select only the number of holes supported by the punch kit installed.

Confidential – for internal use only, do not distribute

"Not Installed"

5. Finisher operations

2-Hole/3-Hole

Table of Contents