Firmware Update; 8.10 Banner Printing - Konica Minolta Magicolor 8650 Service Manual

8. Utility Mode
C. Auth Device Setting
• It will not be displayed when [HDD Installation] is set to "Not Installed".
• It will be displayed only when the following setting shows that [General Settings] is set to
"ON (MFP)".
PageScope Web Connection → [Administrator mode] → [Security] → [Authentication] →
[User Auth/Account Track]
Functions • To set whether or not the authentication device is installed.
Use • Set when the authentication unit (biometric type or card type) is mounted.
Biometric : Uses biometrics (finger vein) authentication system
Card
• When selecting biometrics, set a film timeout interval.
Setting/ <Auth. Mode>
Procedure • The default setting is Not Installed.
<Reading Timeout>
• The default setting is "10 sec".
8.9.6

Firmware Update

Functions • To use when upgrading the firmware.
Use • Use when the administrator of the machine upgrades firmware.
Setting/
See P.51
Procedure

8.10 Banner Printing

• Make the setting for banner printing.
NOTE
• Normal job cannot be accepted during banner printing mode.
Purpose/Use • To use when printing on the long paper.
Setting/ • The default setting is OFF.
Procedure
198
Confidential – for internal use only, do not distribute
: Uses IC card authentication system
"Not Installed"
ON
Field Service Ver. 2.0 Nov. 2007
Card Biometric
10 sec (5 to 60)
"OFF"