3 - 36 MP6000 INTEGRATOR GUIDE
Trim Kit Installation (If Required)
The MX303-SR00004ZZWR trim kit can be used to modify the long MP6000/scale to fit into a counter cut-out
previously occupied by a 12 in. wide NCR scanner/scale. The trim can be mounted on either side of the
MP6000. It should be installed in the downstream side of the conveying goods. The trim adds 0.5 in. (1.2 cm)
to the width of the MP6000.
The kit includes one metal trim, and two Phillips head screws (M4 x 8mm).
To install the trim:
Insert the two screws provided in the rail.
1.
Orient the adapter as shown in the illustration.
2.
Orient the Adapter
Figure 3-45
Attach the side rail to the MP6000, and tighten using a Phillips head screwdriver.
3.
Attach the Adapter
Figure 3-46