Table of Contents
Advertisement
Connecting Power (if required)
If the host does not provide power to the digital scanner, connect an external power supply to the digital scanner:
1. Connect the interface cable to the bottom of the digital scanner, as described in
2. Connect the other end of the interface cable to the host (refer to the host manual to locate the correct port).
3. Plug the power supply into the power jack on the interface cable. Plug the other end of the power supply into an AC outlet.
Configuring the Digital Scanner
To configure the digital scanner, use the bar codes included in this manual, or the 123Scan configuration program.
See
Chapter 4, User Preferences
specific chapter to set up connection to a specific host type.
See
Chapter 9, 123 Scan
to configure the digital scanner using this configuration program. A help file is available in the program.
Mounting the Digital Scanner
Desk Mount
Use the optional desk mount for convenient and protective placement of the digital scanner on a flat surface. Simply place the mount
on the surface. The rubber feet hold the mount securely in place when inserting and removing the digital scanner.
The desk mount can also be secured to a desk surface by inserting two screws* appropriate for the mounting surface through the
screw holes of the desk mount, and into the surface. The desk mount can be screwed onto the surface with or without the rubber feet.
*The recommended screws are two #6 screws (5/8" long).
for information about programming the digital scanner using bar code menus. Also see each host-
Figure 1-4. Inserting the Digital Scanner in the Desk Mount
Getting Started 1-5
Installing the Interface Cable on page
1-4.
Advertisement
Table of Contents
