Checkstand Preparation; Liquid Spills And Moisture; Vertical Clearance; Tools - Motorola MP6000 Integrator Manual

3 - 4 MP6000 INTEGRATOR GUIDE

Checkstand Preparation

If the MP6000 is not replacing an old bioptic device, and you are installing for the first time into a new
checkstand, verify that the area allows for proper cabling, and an AC/DC power supply. Mounting may require
installation of support(s), leveling screws, and peripheral devices. See
details about the location and preparation of the opening.
Preparing the Checkstand
Figure 3-3
IMPORTANT The long (20.0 in./50.2 cm) versions are not available with leveling screws. The checkstand should

Liquid Spills and Moisture

Select a checkstand design which allows fluids to flow through, and directs liquids and moisture build up away
from any electronic equipment or storage areas. Should a liquid spill occur, ensure that moisture can flow
through the checkstand without pooling. The power supply should be away from any area where spills may
occur.

Vertical Clearance

For all configurations of the MP6000, the maximum height above the platter is 5.1 in.; the maximum depth
below the platter is 4.08 in.

Tools

No tools are required to install a MP6000 without a scale, or a Checkpoint antenna. The following tools are
required to mount the Scale Display:
•
Ruler (or similar measuring device)
•
Pencil (or similar measuring device)
•
Drill
•
2.4 mm (3/32 in.) diameter drill bit (to make screw holes where display is to be mounted)
•
19 mm (3/4 in.) diameter drill bit (to make cable pass through hole where display is to be mounted)
•
#2 Phillips screwdriver.
If the optional leveling screws are used on a small or medium MP6000, a Phillips or flat blade screwdriver is
needed.
provide for two leveling screws under the front and rear of the MP6000. The medium (15.7 in./39.9
cm) and short (13.9 in./35.3 cm) MP6000 models have available accessory kits for standard and
long leveling screws.
Counter Cutout on page 3-5 for more