Installing The Mx101 On The Customer's Left Side Of The Tower Cover - Motorola MP6000 Integrator Manual

Slide the CSS tower cover back into place. Ensure the cable service loop folds up into the blank space in
10.
the CSS tower cover, on the opposite side from the scan module. Snaps should click together. When the
tower cover is replaced, the module locks into the grommet compression ribs on the MP6000 inner tower.
Replacing the Tower Cover
Figure 3-23
Replace MP6000 tower bezel. Snap down into place.
11.
Replacing the MP6000 Tower Bezel
Figure 3-24

Installing the MX101 on the Customer's Left Side of the Tower Cover

To install the MX101 on the left side of the MP6000:
SITE PREPARATION AND INSTALLATION 3 - 21