Manually Staging/Configuring Mp6000 Devices - Motorola MP6000 Integrator Manual

5 - 12 MP6000 INTEGRATOR GUIDE

Manually Staging/Configuring MP6000 Devices

Manually staging/configuring MP6000 devices using a USB flash drive is a three step process.
Step 1: Generate the staging files, and load to a USB flash drive.
Step 2: Deploy the USB flash drive to transport staging files to an MP6000.
Step 3: Load the files and configure the MP6000 by inserting the staging flash drive.
The MP6000 has three USB ports which can be used to load files (see
•
Two external ports on the side of the device.
•
One internal port accessible by removing platter. The internal port sits straight up, and includes a cap
cover which must be replaced when the drive is not in use. A missing, or incorrect placement of the cap
does not allow the platter to sit properly when replaced.
IMPORTANT See
Internal USB Port
Internal USB
Port Cap
USB Port Under the MP6000 Platter
Figure 5-10
USB Ports on the MP6000
Figure 5-11
Approved USB Flash Drives for the Flash Drive Well on page 5-14
flash drive dimensions for use in the internal USB port.
External USB Port
USB USB
Flash Drives Flash Drives
Figure 5-10):
for the recommended