Connecting Power (If Required); Configuring The Digital Imager Scanner; Mounting The Digital Imager Scanner; Desk Mount - Motorola Symbol DS6707 Product Reference Manual

Connecting Power (if required)

If the host does not provide power to the digital imager scanner, connect an external power supply:
Connect the interface cable to the bottom of the digital imager scanner, as described in
1.
Cable on page
Connect the other end of the interface cable to the host (refer to the host manual to locate the correct port).
2.
Plug the power supply into the power jack on the interface cable. Plug the other end of the power supply into
3.
an AC outlet.

Configuring the Digital Imager Scanner

To configure the digital imager scanner, use the bar codes in this manual, or the 123Scan configuration program.
See Chapter 4, User Preferences & Miscellaneous Digital Imager Scanner Options
Preferences for information about programming the digital imager scanner using bar code menus. Also see each
host-specific chapter to set up connection to a specific host type.
See Chapter 9, 123Scan
includes a help file.

Mounting the Digital Imager Scanner

Desk Mount

Use the optional desk mount for convenient and protective placement of the digital imager scanner on a flat
surface. Simply place the mount on the surface. The rubber feet hold the mount securely in place when inserting
and removing the digital imager scanner.
Inserting the Digital Imager Scanner in the Desk Mount
Figure 1-4
Alternatively, secure the desk mount to a desk surface by inserting two screws* appropriate for the mounting
surface through the screw holes of the desk mount, and into the surface. Screw the desk mount onto the surface
with or without the rubber feet.
*The recommended screws are two #6 screws (5/8" long).
1-3.
to configure the digital imager scanner using this configuration program. The program
Getting Started
Installing the Interface
and Chapter 5, Imaging
1 - 4