Motorola MP6000 Integrator Manual page 117

To grasp the MP6000 to lower it into the checkstand, use the support handle on the back of the tower
b.
cover together with the front part of the scale, or the handle in the front flange area (if installing the long
model). See Figure 3-40 on page
GRIP
Lowering the Medium MP6000 into the Counter
Figure 3-40
Replace the platter.
c.
Ensure the device is seated properly - see (i) for Long and (ii) for Medium and Short
d.
Long MP6000: The long MP6000 should not rock on the checkstand's adjustable supports
i.
(screws), and the platter must be flush with the surrounding checkstand. If the MP6000 rocks,
remove it, and adjust the checkstand supports (screws). If the MP6000 still rocks, continue to
remove the device and adjust the supports until it sits solidly in the checkstand.
When the platter is flush, its leading edge should be slightly below the checkstand, and the trailing
edge should be slightly above the checkstand.
To ensure smooth scanning, ensure the platter is in place, take a steel can (e.g., a soup can), turn
it over so the harsher seam is facing down, and slide the can over the platter in the standard
scanning direction. The can must not catch on the checkstand, or the platter when swept across all
sections of the platter, in the correct direction.
For the long MP6000, secure the screws in place with lock nuts.
SITE PREPARATION AND INSTALLATION 3 - 31
3-31.
GRIP