Beeper And Led Conditions - Motorola MP6000 Integrator Manual

5 - 20 MP6000 INTEGRATOR GUIDE

Beeper and LED Conditions

NOTE Refer to the MX101 Product Reference Guide (p/n 72E-171320-xx) for beeper and LED conditions for the
CSS device.
Beeper and LED Indicators
Table 5-1
Condition Beeper Indication
ADF Programming
Number expected High, Low Beeps
Alpha character Low, Low Beeps
expected
Criteria or action High, High Beeps
expected
ADF rule saved High, Low, High, Low
Beeps
Criteria or action High, Low, Low Beeps
cleared
Last rule deleted Low Beep
All rules deleted Low, High, High Beeps
ADF out of Low, High, Low, High
memory Beeps
Cancel rule entry Low, High, Low Beeps
Rule error Low, High Beeps
Button Presses
Press and release Click
Scale Zero button
System LED Button LED
Indication Indication
Green No change
Green No change
Green Blinking No change
Green (turns off No change
blinking)
Green No change
Green No change
Green No change
Red No change
Green (turns off No change
blinking)
Red No change
No change Scale Zero
button LED
blinks green
(momentary)
Description
Enter another digit. Add leading
zeros to the front if necessary.
Enter another alphabetic character
or scan the End of Message bar
code.
ADF criteria or action is expected.
Enter another criterion or action, or
scan the Save Rule bar code.
Rule saved. Rule entry mode
exited.
All criteria or actions cleared for
current rule, continue entering rule.
Delete last saved rule. The current
rule is left intact.
All rules are deleted.
Out of rule memory. Erase some
existing rules, then try to save rule
again
Cancel rule entry. Rule entry mode
exited because of an error or the
user asked to exit rule entry.
Entry error, wrong bar code
scanned, or criteria/action list is too
long for a rule. Re-enter criterion or
action.
LED illuminates only if Scale Zero
button is enabled. Causes the
scale to zero.