Pre-Installation Notes - Motorola MP6000 Integrator Manual

3 - 8 MP6000 INTEGRATOR GUIDE
For added protection during shipment, the MP6000 platter is covered with a tight fitting layer of plastic as
2.
shown in Figure
a scale model, just before scale calibration; and, in case of a non-scale model, as the final step of
installation)
Platter Protector
Figure 3-4
CAUTION
Keep the packing (it is the approved shipping container, and should be used if the MP6000 needs to be
3.
returned for servicing), or dispose of the packing in an environmentally sensitive manner.

Pre-Installation Notes

•
If a Scale Display is included, it is recommended to mount it in an appropriate location, preferably where
the old display was mounted. The cable should be routed through the checkstand.
•
If the unit includes a scale, scale calibration is required.
•
If the unit includes EAS Sensormatic:
• its coils require installation
• the large Sensormatic cable should be threaded from the controller box to the coils
• The Sensormatic RS-232 cable should be connected to the unit.
•
If EAS Checkpoint is required, unravel the Checkpoint antenna and ensure a Checkpoint representative
connects the device to the controller.
•
If EAS Checkpoint with interlock is used, connect the interlock cable to the MP6000.
•
All accessories (hand-held scanner, CSS, etc.) require connections.
3-4. This plastic layer must be removed before placing the unit into service. (In the case of
Do not use a sharp object to remove the protector. Doing so can damage the platter.