Removing The Interface Cable; Connecting Power (If Required); Configuring The Digital Scanner - Motorola DS3508 Product Reference Manual

1 - 4 DS3508 Product Reference Guide
Close the clamp, push it back into place and tighten the screws on the clamp to secure the cable into the
4.
bottom of the scanner.
Closing the Cable Clamp
Figure 1-4
Connect the other end of the interface cable to the host (see the specific host chapter for information on host
5.
connections).

Removing the Interface Cable

Loosen the two screws on the cable clamp at the bottom of the scanner and gently pull the clamp away from
1.
the bottom of the scanner.
Open the clamp and unplug the interface cable modular connector from the cable interface port on the bottom
2.
of the scanner handle. Carefully slide out the cable.
Follow the steps for
3.

Connecting Power (if required)

If the host does not provide power to the digital scanner, connect an external power supply:
Connect the interface cable to the base of the digital scanner, as described in
1.
page 1-3.
Connect the other end of the interface cable to the host (refer to the host manual to locate the correct port).
2.
Plug the power supply into the power jack on the interface cable. Plug the other end of the power supply into
3.
an AC outlet.

Configuring the Digital Scanner

To configure the digital scanner use the bar codes included in this manual. See
Miscellaneous Digital Scanner Options
digital scanner using bar code menus. Also see each host-specific chapter to set up connection to a specific host
type.
Installing the Interface Cable on page 1-3
and Chapter 5, Imaging Preferences
to connect a new cable.
Installing the Interface Cable on
Chapter 4, User Preferences &
for information about programming the