Troubleshooting; Diagnostic Led 7-Segment Display - Error And Warning Codes; Led Display Notes; Status Indicator Light - Motorola MP6000 Integrator Manual

A - 2 MP6000 INTEGRATOR GUIDE

Troubleshooting

Diagnostic LED 7-segment Display - Error and Warning Codes

IMPORTANT The information in
The MP6000 includes a one character LED display inside the scanner vertical window. This display provides
status and troubleshooting information, as well as scale legal parameters during calibration (only
configurations with a scale).
Status, warning, and error information are communicated via letter(s) and number(s) scrolled one character at
a time in the LED display. When a message completes, the display pauses for two seconds, then repeats the
sequence continuously.
See Chapter 4, SCALE CALIBRATION (MODELS WITH A SCALE ONLY)
including calibration errors and warnings.

LED Display Notes

• - (dash) indicates normal operating mode.
Scale calibration information (see
•
messages but not over errors.
• Scrolling CAL (number of calibrations performed) and PAR (legal parameter) values display for scale
verification (electronic seal).
Cxxx and Pxxx scroll when the Scale Zero button is held for three or more seconds.
•
An error message displays when a fault condition exists. A power cycle is required. Verify that the
•
subsystems and auxiliary devices are operational.
• A warning message displays when a warning condition exists. The power sequence pauses until the
issue is resolved.

Status Indicator Light

The status indicator light on the MP6000 has three types of displays.
• Center green: Operating normally.
• Red warning: The outer two system LEDs are red; the display appears for .25 seconds every five
seconds.
Red error: All system LEDs turn red and remain red, overriding any other visual system LED sequences,
•
until all errors are resolved.
Table A-1
any error or warning conditions.
Table A-2 on page
and Table A-2 are for reference only. Contact your service provider for
A-6) has precedence over general warning
for detailed calibration information,