Motorola MP6000 Integrator Manual page 108

3 - 22 MP6000 INTEGRATOR GUIDE
Push out the CSS blank side cover on the left side of the CSS tower cover, and replace the cover into the
1.
opening on the right side of the tower cover.
Removing the Side Cover
Figure 3-25
Repeat steps 1, 2, and
2.
Cover on page
Insert the scan module into place facing out of the left side opening of the CSS tower cover. Ensure the
3.
grommets on the scan module align with the sockets in the tower cover, and push into place.
Snap the scan window cover into place on the tower, over the scan window. (See
4.
Connect the USB cable to the top USB port (recommended) on the MP6000 and route the cable through
5.
the side cable slots shown in step
3 from Installing the MX101 on the Customer's Right Side (Default) of the Tower
3-17.
7 on page 3-19.
page 3-19 for diagrams.)