Motorola MP6000 Integrator Manual page 116

3 - 30 MP6000 INTEGRATOR GUIDE
Cutout/Dimensions - MP6000 Long (continued)
11.50 in.
292.2 mm
MP6000 - Long Unit Top View Dimensions
Figure 3-39
To install the MP6000:
Ensure the following items were completed:
1.
Existing scanner and accessories were removed, if applicable. See
a.
and Accessories on page
Cables were connected and routed. See
b.
The Scale Display was installed, if applicable. See
c.
CSS was installed, if applicable. See
d.
Sensormatic coil, or Checkpoint EAS antenna was installed, if applicable. See
e.
Coils on page
Verify checkstand dimensions shown in
2.
Lower scanner in checkstand as follows.
3.
Remove the platter to access the front handle of the device (see
a.
Platter on page
3-7.
Install the Customer Side Scanner (MX101) on page
3-33, or Install Checkpoint Antenna on page
Figure
5-8).
20.0 in.
506.9 mm
Cables and Connections on page
Install the Scale Display on page
3-35.
3-29, Figure 3-33, and Figure
Installing/Removing the Long Scale
Remove Existing Bioptic Scanner
3-15.
3-12.
3-16.
Install Sensormatic
3-37, respectively.