Motorola MP6000 Integrator Manual page 146

4 - 22 MP6000 INTEGRATOR GUIDE
LEDs, and Beeper Sequences (Continued)
Table 4-6
7-segment
Scale State
Diagnostic Display
Successfully Calibration procedure
executing and semantics removed
exiting a scale from display.
legal calibration
Cold reset of No change
scale
Audit Tally - Repeated scroll:
Press and hold C###
Scale Zero
button for
greater than
three seconds
when not in a
Calibration
Mode.
In Bootloader No change
Mode
Scale Error Scrolls fault code:
u##
LED
(System)
No change
No change
No change
P###
then
Off
Red
(Warning)
Scale
Beeper Zero
Sequence Button
(LED)
Three short Solid green
beeps on if weight
stable after
reset of
scale
No change No change
except at Step 5
- Calibration
Success or
Failure - when
the Scale Zero
button is
pressed three
short beeps
tones sound
None No change
None Off
None Off
Optional Scale Display
Scale is reset either by
pressing the Scale Zero
button, scanning the Scale
Reset parameter bar code,
or powering the unit OFF
then ON. The seven
segment test will run.
Seven segment test runs
and displays:
•
00.000 all icons
illuminated for three
seconds
•
Blank for one second
•
99.999 all icons
illuminated for three
seconds
•
Blank for one second
•
Normal display
Blinks between C### and
P###.
None.
Blinks FAIL or blanks
display with unit icon
showing lb or kg
illuminated.
Display can also blink
CALF if the system was in
a scale legal Calibration
Mode.