Affixing The Identification Label - Motorola MP6000 Integrator Manual

Route the cable, looping through the left side cable slots as shown below.
6.
Routing the Cable
Figure 3-26
NOTE The path through the cable slots is not intuitive. Send the cable towards the right of the tower (as shown)
even though the CSS module is on the left. (Take up all the slack outside the MP6000 chassis so the CSS
cable cannot be pinched by the checkstand.)
Connect the cable to the micro USB port on the bottom of the scan module. Ensure the cable is clipped
7.
into the scan module plastic directly below the USB port. (See step
Slide the CSS tower cover back into place. Ensure the cable service loop folds up into the blank space in
8.
the CSS tower cover, on the opposite side of the scan module. Snaps should click together. When the
tower cover is replaced, the module locks into the grommet compression ribs on the MP6000.
Replace MP6000 tower bezel. Snap down into place.
9.

Affixing the Identification Label

IMPORTANT Before you install the MX101, affix the identification label under the MP6000 platter, as shown in
Figure
Peel the label from its backing.
xxxxxxxxxxx
Peel Off Backing
Figure 3-27
3-28. Failure to affix the identification label to the MP6000 voids the MX101 warranty.
SITE PREPARATION AND INSTALLATION 3 - 23
Cable Slots for Left Side
Installation
Scan Module Cable
Clip
9 on page 3-20 for illustration.)