Motorola MP6000 Integrator Manual page 167

Hide thumbs Also See for MP6000:
Table of Contents

Advertisement

Beeper and LED Indicators (Continued)
Table 5-1
Condition
Beeper Indication
Press and hold
Click
Scale Zero button
Press and
Click
hold/release
Scale Zero and
EAS buttons
Press and hold
Five long beeps after 5
Scale Zero and
seconds
Volume/Tone
buttons
Press and release
Click
EAS button
Code 39 Buffering
Code 39
High, Low Beeps
character added
into buffer
Code 39 buffer full 3 Long High Beeps
Code 39 buffer
High, Low, High Beeps
cleared
Code 39 buffer
Low, High, Low Beeps
empty
Code 39 buffer
Low, High Beeps
transmitted
EAS/Security Tags
EAS system
None
disabled
EAS system
None
functional (idle)
EAS tag detected
Configurable: None,
anytime
Geiger Counter clicks
EAS manual
None
deactivation
activated
EAS Soft Tag
None, Beep 1, Beep 2
Deactivation
EAS Hard Tag
None, Beep 1, Beep 2
Detected
System LED
Button LED
Indication
Indication
No change
None
Red after 10
No change
seconds upon
reboot
No change
No change
No change
EAS is enabled,
LED is amber
No change
No change
No change
No change
No change
No change
No change
No change
No change
No change
No change
EAS LED is off
No change
EAS LED is on
No change
EAS LED blinks
yellow at 4 Hz
No change
EAS LED on
No change
No change
No change
No change
OPERATING THE SCANNER 5 - 21
Description
If Scale Zero button is enabled,
causes the scale calibration audit
trail to display until button is
released.
After buttons are held for 10
seconds, a system reboot initiates.
After five seconds, scale calibration
is entered.
If EAS is enabled, button press
activates tag manual deactivation.
New Code 39 data was entered
into the buffer.
Code 39 buffer is full.
The Code 39 buffer was erased.
The Code 39 buffer was erased or
there was an attempt to clear or
transmit an empty buffer.
A successful transmission of
buffered data.
EAS parameter disabled.
EAS is operating normally.
An EAS tag is in the EAS tag
detected area, and being detected.
When deactivation is active on the
system.
Beep indicates that a soft tag was
deactivated.
Beep indicates that a hard tag was
detected.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents