Electrical Power Considerations; Grounding - Motorola MP6000 Integrator Manual

Electrical Power Considerations

The MP6000 may be powered from two different sources:
•
POS Equipment
• IBM register with powered Port 9B interface (using p/n CBA-M51-S16PAR accessory cable)
• NCR POS with powered RS-232 interface (using p/n CBA-R55-S16PAR accessory cable)
• Any register with powered USB interface - 12V only (using p/n CBA-U52-S16PAR accessory cable)
•
AC/DC power cube (using p/n PWRS-140000-148R) with IEC style modular line cord.
Power Supply
Figure 3-2
If using the AC/DC accessory power supply, a 115V/230V outlet must be available in the checkstand near the
scanner.

Grounding

All POS equipment should be properly grounded, and only a three prong IEC style line cord should be used
with the AC/DC accessory power supply.
If you are unsure how to verify proper ground of equipment in the checkstand ask a qualified electrician to
review the equipment installation.
NOTE In an effort to eliminate a possible safety hazard all metal parts of a metal checkstand must be electrically
grounded.
SITE PREPARATION AND INSTALLATION
4.3 in.(+/- 0.01)
110.0 mm (+/- 0.25)
3 - 3