Audit Tallies - Motorola MP6000 Integrator Manual

While performing a shift test, the indication of each position is within the applicable tolerance and the range of
results obtained should not exceed twice the applicable tolerance.
IMPORTANT After verification, record/report audit trail information to the local Weights and Measure authority
where required by law.

Audit Tallies

Audit Tallies (calibration counter = C, legal parameter counter = P) used for scale verification can be shown on
the Scale Display, or the 7-segment display.
Press and hold the Scale Zero button for three seconds to access the calibration tallies (not within
1.
Calibration mode).
C### and P###
a.
C###
represents the number of times the scale reached
i.
successful calibrations are counted.)
P###
The
ii.
changed with or without reaching
When the Scale Zero button is released, the scale returns to normal operation, and the tallies are removed
2.
from both displays.
1.
NOTE This feature is inhibited when the unit is in a scale Calibration Mode.
2.
NOTE If units of weight measure was modified (i.e., kg to lb, or lb to kg) the parameter counter is
incremented by two in the audit tally. This is because the Automatic Zero Setting legal parameter
is being enabled when going from lb to kg, and disabled when going from kg to lb.
SCALE CALIBRATION (MODELS WITH A SCALE ONLY) 4 - 11
tallies blink on the Scale Display and/or scroll on the 7-segment display.
represents the number of times any sealable parameter, or legal parameter was
Calibration Success on page
Calibration Success on page
4-7.
4-7. (Only