Connecting Power (If Required) - Motorola Symbol LS3408-ER Product Reference Manual

1 - 4 Symbol LS3408 Product Reference Guide
Close the clamp, push it back into place and tighten the screws on the clamp to secure the cable into the
4.
bottom of the scanner.
Closing the Cable Clamp
Figure 1-4
Connect the other end of the interface cable to the host (see the specific host chapter for information on host
5.
connections).
NOTE Different hosts require different cables. The connectors illustrated in each host chapter are examples only.
The connectors may be different than those illustrated, but the steps to connect the scanner are the same.

Connecting Power (if required)

If the host does not provide power to the scanner, connect external power to power the scanner:
Connect the interface cable to the bottom of the scanner, as described in
1.
1-3.
Connect the other end of the interface cable to the host (refer to the host manual to locate the correct port).
2.
Plug the power supply into the power jack on the interface cable. Plug the other end of the power supply into
3.
an AC outlet.
Installing the Interface Cable on page