Connecting A Synapse Cable Interface; Connecting Power (If Required); Configuring The Digital Scanner - Motorola Symbol DS6608 Product Reference Manual

Connecting a Synapse Cable Interface

Refer to the Synapse Interface Guide provided with the Synapse cable for detailed setup instructions.
Note
Synapse Smart Cables enable interfacing to a variety of hosts. The Synapse cable has built-in intelligence to detect that host.
To host
Synapse Smart Cable
1. Plug the Synapse adapter cable (p/n 25-32463-xx) into the bottom of the digital scanner, as described in
Interface Cable on page
2. Align the 'S' on the Synapse adapter cable with the 'S' on the Synapse Smart Cable and plug the cable in.
3. Connect the other end of the Synapse Smart Cable to the host.

Connecting Power (if required)

If the host does not provide power to the digital scanner, connect an external power supply to the digital scanner:
1. Connect the interface cable to the bottom of the digital scanner, as described in
2. Connect the other end of the interface cable to the host (refer to the host manual to locate the correct port).
3. Plug the power supply into the power jack on the interface cable. Plug the other end of the power supply into an AC outlet.

Configuring the Digital Scanner

To configure the digital scanner, use the bar codes included in this manual, or the 123Scan configuration program.
See Chapter 4, User Preferences
specific chapter to set up connection to a specific host type.
See Chapter 12, 123 Scan to configure the digital scanner using this configuration program. A help file is available in the program.
Figure 1-4. Synapse Cable Connection
1-4.
for information about programming the digital scanner using bar code menus. Also see each host-
Getting Started 1-5
Synapse Adapter Cable
To digital scanner
Installing the
Installing the Interface Cable on page 1-4.