Field Service Ver. 2.5 Jul. 2006
[8]
[9]
[11]
6.3.43
Separation Claw
1. Remove the Fusing Unit.
See P.37
[1]
[2]
Confidential – for internal use only, do not distribute
4. Remove the wiring saddle [6] and
the harness.
[6]
4040F2C730DA
5. Disconnect the connector [7] of the
Exit Sensor and remove the Exit
Rolls 2 Assy [8].
[7]
4040F2C431DA
6. Remove the screw [9] and the Sepa-
ration Claw Assy [10].
[10]
4040F2C644DA
7. Remove the Exit Roll 2 [11].
4040F2C645DA
2. Snap off the C-clip [1] and remove
the Fusing Entrance Guide Plate [2].
4040F2C625DA
6. Other
91