Hydraulic Control Unit (Hcu); Vehicles Built From: 05/2004 - Ford 2007 WQ Fiesta Repair Manual

206-09A-1 I Anti-Lock Control 206-09A-I 1
REMOVAL AND INSTALLATION
Hydraulic Control Unit (HCU)
-
Vehicles Built From: 0512004
/
!
Remove the brake master cylinder to HCU
Materials
brake tubes.
Name Specification
I
Super DOT 4 brake fluid
I
ESD-M6C57-A
I
Removal
All vehicles
A
CAUTI0N:If brake fluid is spilt on the
paintwork, the affected area must be
immediately washed down with cold water.
1. Detach the engine wiring harness electrical
connector from the wheelhouse assembly.
Right-hand drive vehicles
4. Remove the battery tray.
For additional information, refer to: Battery
Tray (414-01 Battery, Mounting and Cables,
Removal and Installation).
5. CAUTIONS:
h a p the brake tubes to prevent fluid loss
or dirt ingress.
n p l u g the hydraulic control unit (HCU)
ports to prevent fluid loss or dirt ingress.
Left-hand drive vehicles
N0TE:Make a note of the position of the brake
2. Remove the brake master cylinder.
tubes to aid installation.
For additional information, refer to: Brake
Disconnect the brake master cylinder to HCU
Master Cylinder
-
LHD (206-06 Hydraulic
brake tubes from the HCU.
Brake Actuation, Removal and Installation).
I
3. CAUTIONS:
I
h a p the brake tubes to prevent fluid loss
or dirt ingress.
n p l u g the hydraulic control unit (HCU)
ports to prevent fluid loss or dirt ingress.
N0TE:Make a note of the position of the brake
tubes to aid installation.
All vehicles
6. CAUTIONS:
&ap the brake tubes to prevent fluid loss
or dirt ingress.
2006.0 Fiesta
1212006
G406271 en