Table of Contents
Advertisement
206-096-4
Anti-Lock Control
-
Stability Assist
206-096-4
REMOVAL AND INSTALLATION
Hydraulic Control Unit (HCU)
Materials
Remove the brake master cylinder to
hydraulic control unit (HCU) brake tubes.
\
Name
Specification
I
Super DOT4 brake fluid
I
ESD-M6C57-A
7
Removal
A
CAUTI0N:lf brake fluid is spilt on the
paintwork, the affected area must be
immediately washed down with cold water.
1. Remove the brake master cylinder. For
additional information, refer to
Section 206-06 [Hydraulic Brake Actuation].
2. Detach the engine wiring harness electrical
connector from the wheelhouse assembly.
3. CAUTIONS:
h a p the brake tubes to prevent fluid loss
or dirt ingress.
n p l u g the hydraulic control unit (HCU)
ports to prevent fluid loss or dirt ingress.
N0TE:Make a note of the position of the brake
tubes, to aid installation.
4. CAUTIONS:
&ap
the brake tubes to prevent fluid loss
or dirt ingress.
A p l u g the HCU ports to prevent fluid loss
or dirt ingress.
N0TE:Make a note of the position of the brake
tubes, to aid installation.
Disconnect the brake tubes from the HCU.
2006.0 Fiesta
1212006
~ 3 2 7 3 4 1 en
Hide quick links:
Advertisement
Table of Contents
