Ford 2007 WQ Fiesta Repair Manual page 383

21 1-02-35 Power Steering 21 1-02-35
REMOVAL AND INSTALLATION
Item 6
Steering gear to power steering fluid
2. N0TE:Use the front axle crossmember rear
reservoir return line
inner retaining bolts to locate the special
I
tools.
I, Install new O-ring seals onto the power
steering lines.
N0TE:Do not fully tighten the front axle
crossmember rear inner retaining bolts at this
stage.
Using a transmission jack, wooden block
and the special tools, position and align the
front axle crossmember.
2. Connect the power steering lines to the
steering gear valve body.
1. Rotate the power steering lines clamp plate.
2. Install the power steering lines clamp plate
retaining bolt.
3a
&AUTION:W~~I~ tightening the front axle
crossmember front retaining bolts and the
i
front axle crossmem ber rear outer retaining
bolts, make sure that the front axle
crossmember does not move.
Ifem 5
Cable ties
1. Attach the steering gear to power steering
fluid reservoir return line to the power
steering pump to steering gear pressure line.
Install the front axle crossmember front
retaining bolts and the front axle
crossmember rear outer retaining bolts on
both sides.
2006.0 Fiesta
1212006 G458167en