Ford 2007 WQ Fiesta Repair Manual page 118

204-01 -20 Front Suspension 204-01 -20
REMOVAL AND INSTALLATION
Remove the heat shield.
7. Remove the wheel knuckle to strut and
spring assembly pinch bolt.
8. N0TE:Suppot-t the halfshaft. The inner joint
must not be bent more than I 8 degrees. The
outer joint must not be bent more than 45
degrees.
Using the special tool, detach the wheel
knuckle from the strut and spring assembly.
A C A U T I O N : ~ ~ ~ ~
the aid of another
technician, support the strut and spring
assembly.
Remove the strut and spring assembly.
Installation
CAUTIONS:
A
Make sure the heat shield is installed to
prevent damage to the ball joint.
The lower arm pinch bolt must be installed
from the rear of the wheel knuckle.
A
Do not twist the brake hose when installing
the brake caliper to prevent damage to the
brake hose.
f -
,
A
Make sure the brake hose is correctly
located in the brake hose support bracket
to prevent damage to the brake hose.
A
Make sure the brake hose retaining clip is
located on the underside of the brake hose
support bracket to prevent damage to the
brake hose.
I . To install, reverse the removal procedure.
2006.0 Fiesta
1~12006 G I 83760en