Anti-Lock Brake System (Abs) Module-Vehicles Built From: 05/2004; Vehicles Built From: 0512004 .......................... 206-09A-17 - Ford 2007 WQ Fiesta Repair Manual

206-09A-I 7 Anti-Lock Control 206-09A-I 7
REMOVAL AND INSTALLATION
Anti-Lock Brake System (ABS) Module
-
Vehicles Built From:
\
0512004
Materials
Remove the brake master cylinder to HCU
brake tubes.
Name Specification
I
Super DOT 4 brake fluid
I
ESD-M6C57-A
I
Removal
All vehicles
A
CAUTI0N:lf brake fluid is spilt on the
paintwork, the affected area must be
immediately washed down with cold water.
1. Detach the engine wiring harness electrical
connector from the wheelhouse assembly.
Left-hand drive vehicles
2. Remove the brake master cylinder.
For additional information, refer to: Brake
Master Cylinder
-
LHD (206-06 Hydraulic
Brake Actuation, Removal and Installation).
3. CAUTIONS:
&ap the brake tubes to prevent fluid loss
or dirt ingress.
A p l u g the hydraulic control unit (HCU)
ports to prevent fluid loss or dirt ingress.
N0TE:Make a note of the position of the brake
tubes to aid installation.
Right-hand drive vehicles
4. Remove the battery tray.
For additional information, refer to: Battery
Tray (41 4-01 Battery, Mounting and Cables,
Removal and Installation).
5. CAUTIONS:
h a p the brake tubes to prevent fluid loss
or dirt ingress.
n p l u g the hydraulic control unit (HCU)
ports to prevent fluid loss or dirt ingress.
N0TE:Make a note of the position of the brake
tubes to aid installation.
Disconnect the brake master cylinder to HCU
brake tubes from the HCU.
All vehicles
6. CAUTIONS:
2006.0 Fiesta
1212006 G406272en