Stability Assist Module - Ford 2007 WQ Fiesta Repair Manual

206-09C-12 Anti-Lock Control
-
Stability Assist 206-096-1 2
REMOVAL AND INSTALLATION
Stability Assist Module
,/..
,
Materials
Remove the brake master cylinder t o
hydraulic control unit (HCU) brake tubes.
C
Name Specification
I I
I
Super DOT 4 brake fluid
I
ESD-M6C57-A
I
Removal
CAUTI0N:If brake fluid is spilt on the
paintwork, the affected area must be
immediately washed down with cold water.
I . Remove the brake master cylinder. For
additional information, refer to
Section 206-06 [Hydraulic Brake Actuation].
2. Detach the engine wiring harness electrical
I
connector from the wheelhouse assembly.
4. CAUTIONS:
3. CAUTIONS:
h a p the brake tubes to prevent fluid loss
or dirt ingress.
D p l u g the hydraulic control unit (HCU)
ports to prevent fluid loss or dirt ingress.
N0TE:Make a note of the position of the brake
tubes, to aid installation.
h a p the brake tubes to prevent fluid loss
or dirt ingress.
n p l u g the HCU ports to prevent fluid loss
or dirt ingress.
N0TE:Make a note of the position of the brake
tubes, to aid installation.
Disconnect the brake tubes from the HCU.
2006.0 Fiesta
1~12006
G327320en