Ford 2007 WQ Fiesta Repair Manual page 367

21 1-02-1 9 Power Steering 211 -02-19
REMOVAL AND INSTALLATION
Discard the O-ring seals.
/'
\
2. Locate the special tool onto the union and
install the O-ring seal.
11. N0TE:Note the position of the power
steering line to aid installation. 3. Install new O-ring seals onto the power
Remove the power steering pump to steering
steering lines.
gear pressure line.
Installation
1. If a new fluid line is being installed, push the
new line into the new union until it clips into
place.
4. To install, reverse the removal procedure.
5. Fill and bleed the power steering system.
For additional information, refer to: Power
Steering System Filling (211 -00 Steering
System
-
General Information, General
Procedures)
I Power Steering System Bleeding (211-00
2. Using the special tool, install a new O-ring
Steering System
-
General Information,
seal onto the power steering line to power
General Procedures).
steering pump union.
1. Push the new O-ring seal onto the special
tool.
2006.0 Fiesta
1212006
G397028en