206-096-1 3
Anti-Lock Control
-
Stability Assist
206-09C-13
REMOVAL AND INSTALLATION
5. Detach the brake tubes from the bulkhead.
10. Remove the HCU and stability assist
module assembly and the support bracket.
6. Disconnect the stability assist module
electrical connector.
11. Detach the HCU and stability assist module
assembly from the support bracket.
7. Raise and support the vehicle. For additional
information, refer to Section 100-02 [Jacking
12. Remove the HCU to stability assist module
and Lifting].
retaining bolts.
8. Remove the HCU and stability assist module
support bracket lower retaining bolt.
9. Lower the vehicle.
13. Remove the stability assist module.
Installation
I. To install, reverse the removal procedure.
2006.0 Fiesta
1212006
G327320en