Ford 2007 WQ Fiesta Repair Manual page 297

Anti-Lock Control
REMOVAL AND INSTALLATION
Using the special tool, install a new wheel
Using a soft faced hammer and a wooden
/
speed sensor ring (brake disc shown). block, install the dust cap.
Vehicles with rear disc brakes
2. CAUTIONS:
A A v o i d any impact on the wheel speed
sensor ring.
n ~ a k e sure the wheel speed sensor ring
is clean.
A ~ v o i d any contact between the wheel
,
speed sensor ring and a magnetic surface.
(
,
A ~ o t a t e the hub assembly 10 times
counterclockwise when tightening the wheel
hub retaining nut to prevent damage to the
wheel bearing.
Vehicles with rear drum brakes
5. CAUTIONS:
A A v o i d any impact on the wheel speed
sensor ring.
A M a k e sure the wheel speed sensor ring
is clean.
A A v o i d any contact between the wheel
speed sensor ring and a magnetic surface.
Install the brake drum.
For additional information, refer to: Brake
Drum (206-02 Drum Brake, Removal and
Installation).
N0TE:lnstall a new wheel hub retaining nut.
Install the wheel hub.
3. Install the brake disc.
For additional information, refer to: Brake
Disc (206-04 Rear Disc Brake, Removal and
Installation).
4. N0TE:lf the dust cap is damaged a new dust
cap must be installed.
2006.0 Fiesta
1212006 G I 83776en