Table of Contents
Advertisement
206-09A-8
Anti-Lock Control
206-09A-8
REMOVAL AND INSTALLATION
Hydraulic Control Unit (HCU)
-
Vehicles Built Up To: 0512004
! ' -
Materials
Remove the brake master cylinder to
hydraulic control unit (HCU) brake tubes.
Name
S~ecification
I
Super DOT 4 brake fluid
I
ESD-M6C57-A
I
Removal
A
CAUTI0N:If brake fluid is spilt on the
paintwork, the affected area must be
immediately washed down with cold water.
I . Remove the brake master cylinder. For
additional information, refer to
Section 206-06 [Hydraulic Brake Actuation].
2. Detach the engine wiring harness electrical
connector from the wheelhouse assembly.
3. CAUTIONS:
&ap
the brake tubes to prevent fluid loss
or dirt ingress.
n p l u g the hydraulic control unit (HCU)
ports to prevent fluid loss or dirt ingress.
N0TE:Make a note of the position of the brake
tubes, to aid installation.
4. CAUTIONS:
&ap
the braketubes to prevent fluid loss
or dirt ingress.
A p l u g the HCU ports to prevent fluid loss
or dirt ingress.
N0TE:Make a note of the position of the brake
tubes, to aid installation.
Disconnect the brake tubes from the HCU.
2006.0 Fiesta
1212006
G I 83774en
Hide quick links:
Advertisement
Table of Contents
