Brake Booster-Rhd (12 451 0) - Ford 2007 WQ Fiesta Repair Manual

206-07-8 Power Brake Actuation 206-07-8
REMOVAL AND INSTALLATION
Brake Booster
-
RHD(12 451 0)
Removal
2. Remove the brake booster actuating rod pin.
(
1. Remove the brake master cylinder.
For additional information, refer to: Brake
Master Cylinder
-
RHD (206-06 Hydraulic
Brake Actuation, Removal and Installation).
2. Disconnect the brake vacuum pipe from the
brake booster.
I. Unclip the brake vacuum pipe.
2. Disconnect the brake vacuum pipe.
3. Remove the instrument panel lower panel.
1. Remove the lower retaining screws.
2. Remove the upper retaining screws from the
stowage compartment.
3. Release the retaining clip.
5. Remove the brake booster.
Discard the gasket.
Installation
1. WARNINGS:
A D O
not install an Emergency Brake Assist
(EBA) brake booster to a vehicle that is not
equipped with the Anti-lock Brake System
(ABS). Failure to follow this instruction may
result i n personal injury.
A D O
not use a damaged brake pedal.
Failure to follow this instruction may result
in personal injury.
4. Detach the brake booster actuating rod from
CAUTIONS:
the brake pedal (accelerator pedal shown
A
Make sure that the brake booster gasket
removed for clarity).
is correctly positioned on the brake
I. Depress the clip.
booster before installation.
41
A
Do not drop or knock the brake pedal.
Failure to follow this instruction will cause
damage to the brake pedal decoupler
mechanism (if equipped).
2006.0 Fiesta
12/2006 G89214en