21 I -02-9
Power Steering
21 1-02-9
REMOVAL AND INSTALLATION
Discard the O-ring seal.
1. Push the O-ring seal onto the special tool.
2. Locate the special tool onto the union and
install the O-ring seal.
5. Detach the power steering line bracket from
I
TIE001
5852
the engine block.
2. N0TE:Make sure the collar on the hose is
inserted fully into the quick release coupling.
To install, reverse the removal procedure.
3. Fill and bleed the power steering system.
For additional information, refer to: Power
Steering System Filling (211 -00 Steering
System
-
General Information, General
Procedures)
I Power Steering System Bleeding (211-00
Steering System
-
General Information,
General Procedures).
6. Remove the power steering pump.
Installation
1. N0TE:H installing a new power steering
pump, the power steeing pressure line union
supplied with the new pump should be
removed and retained for further use.
Using the special tool, install a new O-ring
seal onto the power steering line to power
steering pump union.
2006.0 Fiesta
1212006
~397031 en