Enabling Tcp/Ip With The Authorization Code; Bypass Mode; Cool Down Mode - Tektronix Phaser 340 Service Manual Addendum

Enabling TCP/IP with the authorization code

Bypass mode

Cool down mode

6 Phaser 340 Color Printer
TCP/IP protocol support is standard in printers serial-numbered BCxx xxx and
up. TCP/IP protocol is optionally supported via a downloaded software key in
earlier printers.
When the Phaser Share Ethernet card is installed, the EtherTalk and Novell
protocols are immediately active. For printer's serial numbered BBxxxxx and
earlier, the Ethernet card's TCP/IP protocol must be activated by a
downloadable authorization code, sometimes referred to as its software key.
The authorization code is printed on a certificate included with the printer (if the
option was factory-installed) or with the field upgrade kit. The Phaser Share User
Manual explains how to activate the authorization code and download it to the
printer . Downloading the code depends on the available computers and cables
as explained in the Phaser Share Network User Manual.
Bypass mode allows you to access the front panel menus (bypassing the engine
and PostScript initializing processes) without having to wait for the printhead to
warm up. This way, you can reset NVRAM or read fault codes immediately.
Meanwhile, the printer continues to warm-up and initialize "in the
background."
1.
Press and hold front panel buttons 1 and 2. Turn on the printer.
2. Wait for the message Entering Bypass Mode to be displayed.
3. Release buttons 1 and 2.
Printers serial-numbered BCxxxxx and up have a menu item that accelerates the
cooling down of the printhead.
1. Enter the extended menu by pressing Menu and Exit .
2. Scroll to the Service Suppor t menu item and press Menu.
3.
Scroll to the item Cool-down for Power Off and press OK .
The printer turn off all the engine heaters and runs the fans on high until the ink
in the printhead has solidified. Then the printers informs you the printer can be
turned off.