Port Configuration - Interlogix IFS NS3601-24P User Manual

Port Configuration

This section allows the user to inspect and configure the current PoE port settings
The page includes the following fields:
Object
• PoE Mode
• Schedule
• Priority
• Maximum Power
IFS NS3601-24P/4S GE-DSSG-244 and 244-POE User Manual
Figure 4-16-3 Power over Ethernet Configuration screenshot
Description
There are three modes for PoE mode.
Enable: enable PoE function..
Disable: disable PoE function.
Schedule: enable PoE function in schedule mode.
Indicates the schedule profile mode. Possible porifles are:
Profile1
Profile2
Profile3
Profile4
The Priority represents the ports priority. There are three levels of power priority
named Low, High and Critical.
The priority is used in the case where the remote devices requires uses more
power than power supply can deliver. In this case the port with the lowest priority
will be turn off starting from the port with the lowest port number.
The Maximum Power contains a numerical value that indicates the maximum
power in watts that can be delivered to a remote device.
Per port maximum value must be less than 15.4 watts, and total ports values
must be less than the Power Budget value if current PoE mode is 802.3af.
Once power overload is detected, the port will automatically shut down and
keep on detection mode until PD's power consumption is lower than the power
limit value.
The IFS-24040HP did not have this parameter.
, screen is shown Figure 4-16-3.
247