Https; Ssh - Interlogix IFS NS3601-24P User Manual

HTTPs

Configure HTTPS on this page. The HTTPS Configuration screen is shown
The page includes the following fields:
Object
• Mode
• Automatic Redirect
Buttons
: Click to save changes.
: Click to undo any changes made locally and revert to previously saved values.

SSH

Configure SSH on this page. This page shows the Port Security status. Port Security is a module with no direct configuration.
Configuration comes indirectly from other modules - the user modules. When a user module has enabled port security on a port, the
port is set-up for software-based learning. In this mode, frames from unknown MAC addresses are passed on to the port security
module, which in turn asks all user modules whether to allow this new MAC address to forward or block it. For a MAC address to be
set in the forwarding state, all enabled user modules must unanimously agree on allowing the MAC address to forward. If only one
chooses to block it, it will be blocked until that user module decides otherwise.
The status page is divided into two sections - one with a legend of user modules and one with the actual port status. The SSH
Configuration screen is shown
The page includes the following fields:
Object
• Mode
IFS NS3601-24P/4S GE-DSSG-244 and 244-POE User Manual
Figure 4-12-4 HTTPS Configuration screen page screenshot
Description
Indicates the HTTPS mode operation. Possible modes are:
Enabled: Enable HTTPS mode operation.
Disabled: Disable HTTPS mode operation.
Indicates the HTTPS redirect mode operation. Automatic redirect web browser to
HTTPS during HTTPS mode enabled. Possible modes are:
Enabled: Enable HTTPS redirect mode operation.
Disabled: Disable HTTPS redirect mode operation.
Figure 4-12-5.
Figure 4-12-5 SSH Configuration screen page screenshot
Description
Indicates the SSH mode operation. Possible modes are:
Enabled: Enable SSH mode operation.
Disabled: Disable SSH mode operation.
Figure 4-12-4.
210